Select the button found on the right side of the NAS server list. ▪ Your NAS and AiMaster are on the same local networkįind your NAS in AiMaster’s NAS server list. ▪ You have logged onto your NAS using AiMaster and have added it to the server list īefore using AiMaster to wake your NAS, please ensure that: Click on the button on the top right-hand corner and navigate to →. You can either use ASUSTOR's Control Center or AiMaster to wake your NAS after it has been powered off. Hold down the power button (in front of the NAS) for 1.5 seconds to shut down the NAS. Next, select the icon at top right corner and then select from the menu. In order to use AiMaster to shut down your NAS, you must first log onto your NAS via AiMaster. Select the icon from the power control menu in ASUSTOR's Portal to shut down your NAS. To use ASUSTOR's Control Center to power off your NAS, select your NAS from the list and click on the button and then select. In order to power off your NAS from within the ADM, select from the menu in the upper right-hand corner of the interface.ģ.2 Powering off the NAS via ASUSTOR's Control Center They will be summarized in the sections below. There are many ways in which you can power off your ASUSTOR NAS. Navigate to → Ĭlick on once you see the popup message. Next, click on the button located at the top. Open up ASUSTOR's Control Center and select your NAS from the list. After installation, open ASUSTOR Control Center to allow it to find your NAS from within your local area network. ASUSTOR Control Center is a NAS management tool that can be installed from the ASUSTOR NAS installation CD or downloaded from the ASUSTOR website. In order to wake up your NAS with ASUSTOR Control center, you will first need to configure a few settings. Ensure that the checkbox has been selected under the Settings section. Select from the left-hand panel and then select the tab. In order to set up WOL for use with your NAS, you will have to configure ADM and ASUSTOR Control Center’s settings.įirst, you will need to ensure that the WOL function has been enabled on the NAS. Users can save power by powering off the NAS when it is not in use and then utilizing WOL to activate the NAS when it is needed again. WOL allows ASUSTOR users to remotely power on their NAS from within their local area network. Students are expected to have a working knowledge of:Ģ.2 Configuring WOL in ASUSTOR Control Centerģ.2 Powering off the NAS via ASUSTOR Control Centerģ.3 Powering off the NAS via ASUSTOR Portalģ.5 Powering off the NAS via the Power ButtonĤ.1 Using ASUSTOR's Control Center to Wake your NASĮach ASUSTOR NAS has a built-in Wake-on-LAN (WOL) function. Power off and then use ASUSTOR's Control Center or AiMaster to wake an ASUSTOR NAS in your local area network Enable the Wake-on-LAN (WOL) function on your ASUSTOR NASĢ. Upon completion of this course you should be able to:ġ.

Mac wake on lan from power off